Assembled kit pictures

Here are some pictures to help you understand your assembled kit better.

1. Assembled arms

1. Motor ids [already configured for you]

1. Connect servo board to power, pc, and the arm itself. Follow this link for a video!

1. How to Mount the Clamp

   1. Choose a Desk or Work Surface Pick a sturdy table or desk edge where you want to mount the clamp arms.

   2. Open the Clamp Press the orange button to release and open the jaws of the clamp.

   3. Adjust Height Move the clamp to the thickness of the desk or work surface with the SO-ARMs on. Slide the jaws up or down to fit properly.

   4. Lock in Place Press the handle until the jaws close tightly around the surface. This secures the clamp strongly.

1. Attaching the Camera to the Follower Arm

   1. Position the camera on the wrist of the follower arm.

   2. Use the M3x12 screw included in the package.

   3. The nut is already placed inside the hole—just insert the screw directly.

   4. Tighten using a 2.5 mm screwdriver.